Cosmetic Chest
Six drawer makeup organizer
Finally finished, not sure if I like how the color turned out. Decided to check measurements this time to make it easier for you guys😁
What you will need
1 4'x8' sheet of ⅜ plywood
bradnails
woodglue
table saw
sander
How to do this project
1

Drawer bottoms are 6½" squares, drawer sides are 1" tall. You could do a 45° angle on the sides to make it look better, but I just butted the connections... You will see in next step(sand ALL pieces)
2

I glued them, then brad nailed them
3

Four 6½"x13 11/16" pieces to go in between, on top, and on the bottom of the drawers. Two side pieces 6½"x7½". And three middle pieces 2"x6½"(sand ALL pieces)
4

Set pieces together to make sure it all fits well
5

Glue and nail together
6

Cut two pieces 7⅞"x15¼" and two pieces 7½"x14¾" then glue opposite sizes together as in picture.(sand)
7

Glue and nail into place
8

Cut six pieces 7"x2¼"(I sanded a rounded edge on the front)
9

Glue into place (do not use nails)
10

Voila!
11

I did a few different finishes, not sure if I like it. Feel free to try your own variety
Comments