Dog Bowl Stand

Beginner First Time Dog Bowl Stand

Play
PlayPause
 
Andy Martinez avatar
Video made by Andy Published on 01/05/2019, viewed by 2696

Was for my dog, first time going at wood working

What you will need

2’ x 4’ plywood, two 1” x 4” x 8’ boards, one 2” x 4” x 6’

skill saw, jig saw, kreg pocket hole mini jig, clamps, wood glue stain and polyurethane

How to do this project

1

Play
, mine are 11”s centered

Cut plywood in a 25” x 15” and cut out two holes for the size bowl you want, mine are 11”s centered

2

Play
gs and then pocket holes and wood glue to attach to the top

Then cut 8 1” x 4” x 15” and made pocket holes to joint to make L shaped legs and then pocket holes and wood glue to attach to the top

3

Play
c finish with foam brush. And then polyurethane oil base coat due to its better with water.

Then cut 2” x 4” to make center stable underneath, and then use stain cognac finish with foam brush. And then polyurethane oil base coat due to its better with water.

4

Play
first try at this and made a lot of mistakes and will not make them again. I am limited to tools so used shag I had, also forgot to sand after the stain. It’s a rough finish now....

Bought 3 1/2” letters to spell out his name and glued them on. This was my first try at this and made a lot of mistakes and will not make them again. I am limited to tools so used shag I had, also forgot to sand after the stain. It’s a rough finish now....

Comments

Avatar placeholder