Wolf Night Light
What you will need
4x6x1/4 inch cedar board ( I used the side of a small box)
Wolf silhouette template (i printed mine on regular printer paper)
Scrollsaw
Drill
Glue stick
Carpenters glue
Night light fixture
Sandpaper
How to do this project
1
Print template... Using glue stick, glue the template directly to the board.(if the board is rough it may need sanded before this step, mine was already smooth)
2
Carefully drill a hole on the inside of the waste material inside the silhouette
3
Feed the scrollsaw blade through the hole, cut out the inside lines
4
Take the blade out of the work, replace blade in the saw and cut the silhouette on the outside
5
Using a drillbit the size of the light fixture, drill a hole in the board that was left over
6
Cut around the outside of this hole, creating a ring with a straight edge on one side
7
Pieces should look like this at this point
8
Dip the silhouette in warm water and wipe off excess pieces of the template
9
Glue the ring to the silhouette with the carpenters glue. Only a small dab of glue will work
10
Slip the ring over the light fixture, insert light bulb
11
Plug it in!!!
Comments